How to Replace Nylon in a Brush Cutter Tap & Go/Nylon Trimmer
Replacing nylon in a brush cutter’s tap-and-go system is a relatively simple process. Here’s a general guide:
Table of Contents
Tools Needed:
- A pair of pliers
- A screwdriver (if needed)
Steps:
- Stop the Engine: Ensure the brush cutter is turned off and cooled down before proceeding.
- Locate the Tap & Go Head: This is the part where the nylon line feeds out.
- Release the Spool: Depending on your model, you may need to unscrew a cap or press a button to release the spool.
- Remove the Old Line: Pull out the remaining old nylon line.
- Insert New Line:
- Manual Feed Models:
- Thread the new nylon line into the spool’s eyelet or groove.
- Wind the line around the spool, ensuring it’s tightly wound.
- Cut the excess line, leaving a few inches to feed through the cutting head.
- Tap & Go Models:
- Insert the end of the new nylon line into the designated slot on the tap & go head.
- Tap the head on the ground to feed the line.
- Manual Feed Models:
- Reassemble the Head: If you disassembled the head, reassemble it, ensuring all parts are securely in place.
- Test the Line: Start the brush cutter and gently tap the head on the ground to feed the new line.
Additional Tips:
- Line Length: Ensure the line is not too long or too short. Too long can cause tangling, while too short may not provide enough cutting length.
- Line Quality: Use high-quality nylon line designed for your specific brush cutter model.
- Regular Maintenance: Periodically check the tap & go head for wear and tear. Replace worn parts as needed.
Visual Guide: For a more detailed visual explanation, you can refer to online tutorials or consult the user manual for your specific brush cutter model. Many manufacturers provide detailed instructions and helpful diagrams.
Remember: Always wear protective gear, including eye protection, gloves, and sturdy footwear, when operating a brush cutter.
By following these steps and taking necessary precautions, you can easily replace the nylon line in your brush cutter and keep it working efficiently.
FAQ: Replacing Nylon Line in a Brush Cutter
Q: How do I replace the nylon line in my brush cutter’s tap & go head?
A:
- Stop and Cool: Turn off the brush cutter and let it cool down completely.
- Access the Head: Locate the tap & go head and release the spool (may involve unscrewing a cap or pressing a button).
- Remove Old Line: Pull out the remaining old line.
- Insert New Line:
- Manual Feed: Thread the new line through the spool eyelet, wind it tightly, and cut off excess.
- Tap & Go: Insert the line end into the designated slot and tap the head on the ground.
- Reassemble: If disassembled, reassemble the head securely.
- Test: Start the cutter and tap the head to feed the new line.
Q: What tools do I need to replace the nylon line?
A:
- Pliers
- Screwdriver (possibly, depending on the model)
Q: How long should the new nylon line be?
A:
- Avoid making it too long (causes tangles) or too short (insufficient cutting length).
- Refer to your brush cutter’s manual for specific recommendations.
Q: What type of nylon line should I use?
A:
- Use high-quality nylon line specifically designed for your brush cutter model.
Q: What safety precautions should I take?
A:
- Always wear protective gear, including eye protection, gloves, and sturdy footwear, when operating a brush cutter.
Q: Where can I find more detailed instructions?
A:
- Consult your brush cutter’s user manual for specific instructions and diagrams.
- Search online for tutorials specific to your brush cutter model.